Multi-Tech Systems MTS2SA-T - Manual (Page 87)

Chapter 10
− Modem Mode AT Commands, S-Registers, and Result Codes
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 87
Call Control Commands
+MS Modulation Selection
+MR Modulation Reporting Control
%E Enable/Disable Line Quality Monitor and Auto-Retrain
%U Select µ-Law or A-Law Codec Type
B Communication Standard – CCITT or Bell
Error Control Commands
+ES Error Control
+EB Break Handling in Error Control Operation
+ESR Selective Repeat
+EFCS 32-bit Frame Check Sequence
+ER Error Control Reporting
+ER Report the Current Error Control
+ETBM Call Termination Buffer Management
\B Transmit Break to Remote
\K Break Control
-K MNP Extended Services
Data Compression Commands
+DS Data Compression
+DR Data Compression Reporting
%C Enable/Disable Data Compression
V.8/V.8bis Commands
+A8E V.8 and V.8bis Operation Controls
+A8I CI Signal Indication
Diagnostic Commands
#U Last Call Status Report
FastConnect Commands
$F FastConnect Control
V.92 +P and -Q Commands
+PCW Call Waiting Enable
+PMH Modem-on-Hold Enable
+PMHR Initiate Modem-on-Hold
+PMHT Modem-on-Hold Timer
+PIG PCM Upstream Ignore
+PMHF V.92 Modem-on-Hold Hook Flash
+PQC V.92 Phase 1 and Phase 2 Control
+PSS Use Short Sequence
-QCPC Force Full Startup Procedure on Next Connection
-QCPS Enable Quick Connect Profile Save