Setup and configuration prerequisites – Multi-Tech Systems MTS2SA-T User Manual
Page 144

Chapter 13 – SMTP Client
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
144
Setup and Configuration Prerequisites
The following details are mandatory for configuration and have to be validated before sending an email:
• Host Interaction Mode enabled to restrict Telnet-Dialout and PPP.
Command:
set serial
• Set SMTP server name or IP address of maximum length 64 characters.
Command:
set send-mail smtp-server-name
• Set SMTP server port.
Command:
set send-mail smtp-server-port <25>
•
Set Host name of maximum length 64 characters.
Command: set send-mail host-name
•
Set From address identity of maximum length 64 characters.
Command: set send-mail from-address-identity
•
Set From address of maximum length 64 characters.
Command: set send-mail from-address
Notes:
1.
The send-mail command prompts for the ERROR message if any of the above details
are not configured or not valid.
2.
The following configuration suggestions are optional:
•
Set reply-to address of maximum length 64 characters. By default the server takes
the from address as the reply-to-address.
•
If this is configured, this address is taken as the reply to address.
set send-mail reply-to-address