beautypg.com

Multi-Tech Systems MTS2SA-T User Manual

Page 32

background image

Chapter 4 – Command Line Interface (CLI)

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)

32

Serial Commands – Setup

Command Syntax

set serial [s0] auto-dialout-port

Description

If auto-dialout is enabled, specifies the auto dialout-port on which the client
can connect.
Default is 5000.

Note:

The port number should be other than standard TCP ports.

This command is valid only for device port S0.

Default Value

5000

Success

OK

Error

1. Too few arguments

“Usage: set serial s0 auto-dialout-port

Type ‘set serial s0 auto-dialout-port ? for more information”

2. Multiple matches

auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout

auto-dialin-port auto-dialout-port

3. Invalid Port Number

“error: Invalid port number

Type ‘set serial s0 auto-dialout-port ? for more information”

4. If “set serial s1 auto-dialout-port 5000” is given
“error: Command not supported on modem port s1”


Command Syntax

set serial [s0] auto-dialout-protocol

Description Note:

This syntax gives a provision for future extensibility. .
This command is valid only for device port S0.

Default Value

Telnet

Success

OK

Error

1. Too few arguments

“Usage: set serial s0 auto-dialout-protocol

Type ‘set serial s0 auto-dialout-protocol ?’ for more information”

2. Multiple matches

auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout

auto-dialin-port auto-dialout-port

3. Invalid string
error:

Invalid

parameter

Type ‘set serial s0 auto-dialout-protocol ?’ for more information”

4. If “set serial s1 auto-dialout-protocol telnet” is given
“error: Command not supported on modem port s1”

Command Syntax

set serial [s0/s1] baud-rate

Description

Sets the serial baud rate.

Default Value

115200

Success

OK

Error

1. Too few arguments

“Usage: set serial s0/s1 baud-rate

Type ‘set serial s0/s1 baud-rate ?’ for more information”

2. Invalid baud-rate

“error: baud-rate range : [300,……]

Type ‘set serial s0/s1 baud-rate ?’ for more information”

This manual is related to the following products: