Multi-Tech Systems MTS2SA-T - Manual (Page 44)

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 44
PPP Commands – Setup
Command Syntax set ppp local-ip-addr mask
Description During IPCP negotiations, the configured IP address is sent for the local
interface. In the case where the peer is requested to provide the IP
address, it can be configured as 0.0.0.0
Default Value 0.0.0.0
255.255.255.0
Success OK
Error 1. Too few arguments
Possible arguments are IP Address and Mask
2. Invalid IP address/Mask
Invalid argument
Command Syntax set ppp password
Description Sets the password that remote peers will use for authentication.
Default Value Ipmodule
Success OK
Error 1. Password Length
Password should have minimum of 8 characters
Command Syntax set ppp remote-ip-addr mask
Description During IPCP negotiations, this configured IP address is sent for the remote
interface. In the case of the peer being requested to provide the IP address,
it can be configured as 0.0.0.0
Default Value 0.0.0.0
255.255.255.0
Success OK
Error 1. Too few arguments
Possible arguments are IP Address and Mask
2. Invalid IP address/Mask
Invalid argument
Command Syntax set ppp username
Description Sets the user name that the remote peer will use for authentication.
Default Value Ipmodule
Success OK
Error 1. Too few arguments
Possible value(s) are valid user name