Multi-Tech Systems MTS2SA-T User Manual

Page 72

Chapter 7 – Telnet Dialout

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)

Commands to Setup Auto Dial-out in RAW-Mode for MultiConnect IP

# set ip telnet auto-dialout enable

# set ip telnet raw-mode enable

# set serial s0 stop-bits 1

# set serial s0 baud-rate 115200

# set serial s0 data-bits 8

# set serial s0 parity none

# set serial s0 flow-control rts-cts

# set serial s0 auto-dialout enable

# set serial s0 raw-dialout enable

# set serial s0 auto-dialout-port 5000

# set serial s0 auto-dialout-protocol telnet

# set serial s1 stop-bits 1

# set serial s1 baud-rate 115200

# set serial s1 data-bits 8

# set serial s1 parity none

# set serial s1 flow-control rts-cts

# set serial s1 connect-type modem

# set serial s1 modem dial-number 123

# set serial s1 modem dialing-trig-mode none

(Refer to Chapter 6 – Prerequisite Configurations - Physical Link Established over the Modem

Port for more details)

# set ppp ppp0 ipcp-mode client-only

# set ppp ppp0 username "MultiConnect"

# set ppp ppp0 password "MultiConnect"

# save

Once the physical link is up and PPP interface has acquired an IP address the

MultiConnect IP is ready to accept Auto dialout connection.

Use a Telnet client and connect to 202.54.39.95 on port 5000 (RAW TCP socket). This eventually

establishes a Telnet auto-dial-out session (In RAWMODE) with the MultiConnect IP, thereby
opening the serial port for use.

Closing the Telnet client closes the serial port in use.

Notes:
1.

You cannot open more than one dialout session to the same port.

When the Dialout session authentication is enabled as specified in the

Optional Configuration

Commands

, the session prompts for a user name and password before opening the session

successfully.

The serial port is opened with the current serial configuration.

This manual is related to the following products: