Multi-Tech Systems MTS2SA-T User Manual
Page 37

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
37
Serial Commands – Setup
Command Syntax
set serial [s1] modem dialing-trig-mode
Description
Sets the dialing trigger mode for the modem port S1.
If dialing trig mode is none:
The serial interface will initialize the modem and dial as per the configured
parameters.
If dialing trig mode is dtr:
As soon as a serial device is connected to S0 (DTR goes high), the S1
serial interface will initialize the modem and dial as per the configured
parameters.
If dialing trig mode is command:
The serial interface will dial only on demand. The possible commands that
can trigger the link are:
•
"linkup s1" command is issued
•
Application trigger (SMTP, POP3 Client, etc)
Note:
This command triggers a reboot upon save.
Default Value
Command
Success
OK
Error
1. Too few arguments
"Usage: set serial s1 modem dialing-trig-mode
Type 'set serial s1 modem dialing-trig-mode ?' for more information"
2. Invalid string
"error: Invalid string
Type 'set serial s1 modem dialing-trig-mode ?' for more information"
Command Syntax
set serial s1 modem country-code
Description
Sets the modem country code value to
This command is valid only for port S1.
Default Value
-
Success
OK
Error
1. Too few arguments
“Usage: set serial s1 modem country-code value
Type ‘set serial s1 modem country-code value ?’ for more information”
Command Syntax
set serial [s0/s1] modem hangup-string
Description
Sets the Modem hang-up string.
Triggers for a reboot upon save.
Default Value
+++ATH0
Success
OK
Error
1. Too few arguments
"Usage: set serial s0/s1 modem hangup-string
Type 'set serial s0/s1 modem hangup-string ?' for more information"