Multi-Tech Systems MTS2SA-T User Manual
Page 24

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
24
IP Commands – Setup
Command Syntax
set ip syslogd-server
Description
Sets the remote syslog server's IP address.
Default Value
0.0.0.0
Success
OK
Error
1. Too few arguments
“Usage: set ip syslogd-server
Type ‘set ip syslogd-server ?’ for more information”
2. Invalid
IP
address
“error: Invalid IP address
Type ‘set ip syslogd-server ?’ for more information”
Command Syntax
set ip tcp-keepalive
Description
Sets the TCP keep-alive timeout for the MultiConnect IP.
't' : range from 3-120 minutes
Default Value
3 minutes
Success
OK
Error
1. Too few arguments
“Usage: set ip tcp-keepalive
Type ‘set ip tcp-keepalive ?’ for more information”
2. Invalid
IP
address
“error: Invalid value, rante [3-120] mins
Type ‘set ip tcp-keepalive ?’ for more information”
Command Syntax
set ip telnet
Description
Enables/disables the Telnet Server. This is a global setting, which will
enable/disable the Telnet Server in the MultiConnect IP.
Note:
Upon disabling Telnet server, the administrator cannot configure the
MultiConnect IP over the built-in Modem interface (wherein PPP has
acquired IP Address). The only option is to connect through a terminal
application over the Serial port.
Default Value
Enabled
Success
OK
Error
1. Too few arguments
Too few arguments. Possible argument(s) are
set ip telnet
Type : set ip telnet ? for more information)
2. Multiple matches
telnet
telnet-port
3. Invalid String
Invalid argument "invalid string"
Valid arguments are
auto-dialout escape-string
inactivity inactivity-timeout
escape-monitor raw-mode
Possible
value(s)
are
enable or disable