Multi-Tech Systems MTS2SA-T - Manual (Page 42)

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 42
PPP Commands – Setup
PPP Setup Commands
Note: All PPP Commands use the ppp0 interface, which corresponds to the modem port S1.
Command Syntax set ppp authentication
Description Enables/disables PPP Authentication.
Default Value Disabled
Success OK
Error 1. Too few arguments
Possible argument(s) are disable and enable
2. Invalid string
Invalid argument.
Valid argument(s) are disable and enable
3. Multiple matches: auth-type and authentication
Command Syntax set ppp auth-type
Description Sets the protocol to authenticate the remote peer: PAP/CHAP/PAP-CHAP
Default Value PAP
Success OK
Error 1. Too few arguments
Too few argument(s). Possible argument(s) are:
chap, pap, and pap-chap
2. Invalid authentication type
Invalid argument. Valid argument(s) are
chap, pap, and pap-chap
3. Multiple matches: auth-type and authentication
Command Syntax set ppp compression
Description Enables/disables CCP compression.
Default Value Disabled
Success OK
Error 1. Too few arguments
Possible argument(s) are disable and enable
2. Invalid string
Invalid argument. Valid argument(s) are disable and enable
Command Syntax set ppp comp-type
Description Sets the compression type to BSD, DEFLATE or BOTH.
In the case of NON-RAWMODE:
When both is configured as the compression type, the module tries to
negotiate DEFLATE first. In the event of failure, the BSD is negotiated.
In case of RAW-MODE:
Compress-type both is not supported in RAW-MODE, since there are no
negotiations between MultiConnect IP Modules.
Default Value Deflate
Success OK
Error 1. Too few arguments
Too few argument(s). Possible argument(s) are both, bsd, deflate
2. Invalid string
Invalid argument "string"
Valid argument(s) are both, bsd, deflate