Multi-Tech Systems MTS2SA-T - Manual (Page 29)

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 29
Serial Commands – Setup
Command Syntax set serial [s0] auto-dialin
Description Enables/disables the device port to Internet connectivity for the serial port
S0. This command is valid only for device port S0
Default Value Disabled
Success OK
Error 1. Too few arguments
“Usage: set serial s0 auto-dialin
Type ‘set serial s0 auto-dialin ? for more information”
2. Multiple matches
auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout
auto-dialin-port auto-dialout-port
3. Invalid string
“error: Invalid string
Type ‘set serial s0 auto-dial-in ? for more information”
4. If “set serial s1 auto-dialin ” is given
“error: Command not supported on the modem port s1”
Command Syntax set serial [s0] auto-dialin-ipaddress
Description Specifies the auto dial-in IP address.
Note: When a connection is established from serial, a session is
established to the IP address mentioned above.
This command is valid only for device port S0.
Default Value NULL
Success OK
Error 1. Too few arguments
“Usage: set serial s0 auto-dialin-ipaddress
Type ‘set serial s0 auto-dialin-ipaddress ? for more information”
2. Multiple matches
auto-dialin auto-dialin-protocol auto-dialout-protocol
auto-dialin-ipaddress auto-dialout
auto-dialin-port auto-dialout-port
3. Invalid IP Address
“error: Invalid IP address
Type ‘show serial s0 auto-dialin-ipaddress ? for more information”
4. If “set serial s1 auto-dialin-ipaddress 192.168.2.2” is given
“error: Command not supported on the modem port s1”