beautypg.com

Serial setup commands – Multi-Tech Systems MTS2SA-T User Manual

Page 27

background image

Chapter 4 – Command Line Interface (CLI)

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)

27

Serial Commands – Setup

Serial Setup Commands

Command Syntax

set serial auto-telnet

Description

This command globally enables serial auto dial-in support.

Notes:

This feature provides a Telnet session to the serial device connected to S0
through the IP-enabled modem port (S1)
Also, Telnet can be used only after PPP is up and has acquired an IP
address on the modem's (S1) port.

Default Value

Disabled

Success

OK

Error

1. Too few arguments
“Usage: set serial auto-telnet
Type ‘set serial auto-telnet ?’ for more information”
2. Invalid string
error: Invalid string
Type ‘set serial auto-telnet ?’ for more information

Command Syntax

set serial escape-monitor

Description

Sets a ‘‘monitor’’ flag that enables/disables the scanning of escape
sequence.

Default Value

Enable

Success

OK

Error

1. Too few arguments
“Usage: set serial s0/s1 escape-monitor
Type ‘set serial s0/s1escape-monitor ?’ for more information”
2. Multiple matches

escape-monitor
escape-string

3. Invalid string

error: Invalid string

Type ‘set serial s0/s1 escape-monitor ?’ for more information”

Command Syntax

set serial escape-string

Description

The Telnet client scans for this escape sequence and transfers the control to
the command parser.
By default, the Telnet client scans for “+++inet”.

Default Value

+++ inet

Success

OK

Error

1. Too few arguments

“Usage: set serial s0/s1 escape-string

Type ‘set serial s0/s1 escape-string ?’ for more information”

2. Multiple matches

escape-monitor
escape-string

This manual is related to the following products: