beautypg.com

Scenario 2 – serial auto dial-in in telnet mode, Prerequisites – Multi-Tech Systems MTS2SA-T User Manual

Page 76

background image

Chapter 8 – Auto Dial-in Feature

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)

76

Scenario 2 – Serial Auto Dial-in in Telnet Mode

This example shows how to setup a serial auto dial-in session in Telnet mode. The auto dial-in session is
opened by Telnet client embedded in the MultiConnect IP to the configured server on a configured port.

Once the session is opened successfully, there can be two-way traffic between the serial device and the
remote server.

You can switch from Command Prompt to Dial-in session using the restore session command.

You can switch from Dial-in session to Command Prompt using .

Prerequisites

RAW mode (Global and each port) MUST BE DISABLED using the following command:

Enable/Disable the RAW mode globally for all Auto-Dial-in sessions:

# set ip telnet raw-mode




Auto Dial-in Feature in Telnet Mode

This manual is related to the following products: