Gateway 9715 - Manual (Page 86)

81 www.gateway.com
Installing drives
2
If you are replacing a failed drive, determine which drive has failed by checking the
drive status LEDs on the front of the drive carriers.
3
Remove the drive carrier by pressing the drive latch and pulling the drive tray lever
to the right (away from the server), then pull the tray straight out of the server.
4
If you are replacing a hard drive, remove the four screws that secure the hard drive
to the drive carrier, then remove the drive from the carrier.
Caution
Before you remove a failed drive, use the appropriate software and
utilities installed on the server to stop all activity on the failed drive.
Instructions for using the software are provided by the software
manufacturer. Failure to do so may destroy the data on the drive.
Drive status
LED
Drive latch
8510702.book Page 81 Thursday, July 7, 2005 11:21 AM