Gateway 9715 - Manual (Page 127)

122 www.gateway.com
Chapter 4: Installing Components
10
If you are installing the VRM for the fourth processor, reinstall the VRM air baffle.
11
Replace the fibre channel module by following the instructions in “Installing or
removing the fibre channel module” on page 108 .
12
Replace the memory boards or memory board air baffles into memory slots C and D
by following the instructions in
“Installing and removing memory boards” on
page 85 .
13
Replace the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
14
Follow the instructions in “Closing the server case” on page 72 .
To remove a processor core VRM:
1
Follow the instructions in “Preventing static electricity discharge” on page 65 .
2
Follow the instructions in “Opening the server case” on page 66 .
3
Remove the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
4
Remove the memory boards or memory board air baffles from memory slots C and
D by following the instructions in
“Installing and removing memory boards” on
page 85 .
5
Remove the fibre channel module by following the instructions in “Installing or
removing the fibre channel module” on page 108 .
Important
The processor core VRM sockets are located on the system board,
under the center brace, however you do not need to remove the center
brace to install or remove the VRMs.
8510702.book Page 122 Thursday, July 7, 2005 11:21 AM