Gateway 9715 - Manual (Page 80)

75 www.gateway.com
Installing drives
7
Lift up on the right-rear corner of the CD or DVD drive to disengage it from the drive
carrier, then remove it from the carrier.
8
Disconnect the SATA-to-IDE converter board from the back of the drive, then place
the drive in an anti-static bag for storage.
9
Slide the empty drive carrier back into the server.
- OR -
If you are replacing the drive, see “To install a CD or DVD drive:” on page 75 , and
begin at Step 6 .
10
Reconnect the front panel cable to the SCSI hot-swap backplane by following the
instructions in
“Replacing the SCSI hot-swap backplane” on page 139.
11
Replace the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
12
Follow the instructions in “Closing the server case” on page 72 .
To install a CD or DVD drive:
1
Follow the instructions in “Preventing static electricity discharge” on page 65 .
2
Follow the instructions in “Opening the server case” on page 66 .
3
Remove the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
4
Remove the front panel cable from the SCSI hot-swap backplane by following the
instructions in
“Replacing the SCSI hot-swap backplane” on page 139 .
8510702.book Page 75 Thursday, July 7, 2005 11:21 AM