Gateway 9715 - Manual (Page 16)

11 www.gateway.com
Setting up the hardware
Converting to pedestal configuration
To convert your server to a pedestal configuration, you need a pedestal conversion kit. To
order the conversion kit, contact Gateway Customer Care, Gateway Sales, or visit
accessories.gateway.com . For more information on contacting Customer Care, see
“Telephone support” on page 223.
Contents of the conversion kit
The pedestal conversion kit contains the following:
■ Outer cover (1)
■ Phillips screws (6)
■ Caster assemblies (4)
■ Pedestal face plate (1)
■ Torx screws (6)
Tools required
You need the following tools to convert to the pedestal configuration:
■ Phillips head screwdriver (#2)
■ Torx screwdriver
To convert your server to the pedestal configuration:
1
Follow the instructions in “Preventing static electricity discharge” on page 65 .
2
Remove the server from the rack cabinet, if necessary.
3
Remove the slide rails and cable management arm (if installed).
4
Remove the optional control panel (if installed), by following the instructions in
“Removing and installing the control panel” on page 84 .
Warning
Lifting the server or removing it from the rack is a two-person job. If
needed, use an appropriate lifting device. A fully loaded Gateway
9715 server weighs about 130 lbs (60 kg).
8510702.book Page 11 Thursday, July 7, 2005 11:21 AM