Bios, Cd or dvd drive, Bios cd or dvd drive – Gateway 9715 User Manual
Page 219
214
www.gateway.com
Chapter 7: Troubleshooting
BIOS
The settings in the BIOS Setup utility are not retained
■
Replace the CMOS battery. For more information, see
.
CD or DVD drive
Your server does not recognize a CD or DVD, or the CD or DVD drive
■
Restart your server, then open the BIOS Setup utility by pressing any key when the
Gateway logo appears. When the System Options menu opens, select
BIOS Setup utility
,
then press E
NTER
. Make sure that the IDE controllers are enabled. For more
information, see
“Using the BIOS Setup Utility” on page 153
.
■
Reinstall the device driver. For more information, see Using Your System Companion CD.
■
Make sure that the drive is configured correctly by following the instructions in the
drive’s documentation.
■
Open your server case and make sure that the cables are connected correctly to the
CD or DVD drive and the connector on the hot-swap backplane, system board, or
controller card.
85E0
Memory board A - memory bad or missing
Major
Pause
85E8
Memory board B - memory bad or missing
Major
Pause
85F0
Memory board C - memory bad or missing
Major
Pause
85F8
Memory board D - memory bad or missing
Major
Pause
85E1
Memory board A - memory not configured
Major
Pause
85E9
Memory board B - memory not configured
Major
Pause
85F1
Memory board C - memory not configured
Major
Pause
85F9
Memory board D - memory not configured
Major
Pause
85FC
System memory bad or missing
Major
Pause
85FD
System memory not configured
Major
Pause
Error
code
Error message
Severity
Response
8510702.book Page 214 Thursday, July 7, 2005 11:21 AM