Gateway 9715 - Manual (Page 184)

179 www.gateway.com
Configuring your ROMB RAID solution with the RAID Web Console
Registration server operation
When the networking option is enabled in Web Console, the RAID server will look up
the registration server address in the regserv.dat file and resolve it to an IP address through
the hosts file or through DNS resolution. The RAID server will then register its name and
address with the registration server. Each RAID server that is registered with the registration
server will display on the Web Console screen.
A RAID server or a client system that does not have a RAID controller installed can be
used to remotely manage a RAID server through a standard Web browser interface. To do
this, point the browser at the registration server using either the host name or the IP address
of the registration server, such as
http://w2k:3570 or http://192.168.1.1:3570 .
The Local SetPass utility must be used to set a password on each RAID server. SetPass is
installed as part of the Web Console installation.
8510702.book Page 179 Thursday, July 7, 2005 11:21 AM