Reclaiming hot spare disks, Reconfiguring existing arrays, Adding a physical drive to an existing array – Gateway 9715 User Manual
Page 195
190
www.gateway.com
Chapter 6: Configuring your RAID solutions
To check the rebuild rate:
■
Select the correct adapter from the
Adapter
box, then select
Rebuild Rate
from the
Adapter menu. If there is more than one adapter in the system, click each adapter and
check the rebuild rate. The rebuild rate is not affected when you clear the
configuration.
To Exit the Web Console:
■
Select
Exit
from the Configuration menu to quit the Web Console.
Reclaiming hot spare disks
To reclaim hot spare disks:
■
Select the drive and select
Remove Hot Spare
from the right pane. The Web Console
changes the state of the selected drives to the READY state.
Reconfiguring existing arrays
This section provides instructions for adding and removing physical drives from existing
arrays.
Adding a physical drive to an existing array
To add a physical drive to an array:
1
Go to the Config View screen.
2
Highlight the logical drive and select properties from the left pane. Select the drive
to add from the
Add Physical Drive
pane.
8510702.book Page 190 Thursday, July 7, 2005 11:21 AM