Gateway 9715 - Manual (Page 82)

77 www.gateway.com
Installing drives
12
Reconnect the front panel cable to the SCSI hot-swap backplane by following the
instructions in
“Replacing the SCSI hot-swap backplane” on page 139.
13
Replace the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
14
Follow the instructions in “Closing the server case” on page 72 .
Installing a fixed, removable-media drive in a 5.25-inch
drive bay
Use these instructions to install or replace a CD, DVD, or tape drive.
To install a 5.25-inch drive:
1
Follow the instructions in “Preventing static electricity discharge” on page 65 .
2
Follow the instructions in “Opening the server case” on page 66 .
3
If you are replacing a drive, go to Step 5 .
- OR -
Caution
Cooling and EMI constraints do not permit the installation of an IDE
hard drive in either of the 5.25-inch drive bays.
Caution
CD, DVD, and tape drives are not hot-swappable, so the server must
be turned off and the AC power cords removed prior to installing,
removing, or servicing these devices.
Important
Two half-height or one full-height SCSI tape drive can be installed in
the available 5.25-inch drive bays.
8510702.book Page 77 Thursday, July 7, 2005 11:21 AM