Gateway 9715 - Manual (Page 76)

71 www.gateway.com
Removing and installing the center brace
To install the center brace:
1
Align the center brace with the guides on both sides of the case and with the
full-length PCI expansion cards to the back, then lower the center brace into the case
until it is fully seated.
2
Move the two center brace locks (located on both sides of and behind the center brace)
toward the front of the case to lock the center brace into place.
3
Follow the instructions in “Removing and installing the processor air baffle” on
page 67 .
4
Follow the instructions in “Closing the server case” on page 72 .
Center brace
8510702.book Page 71 Thursday, July 7, 2005 11:21 AM