Gateway 9715 - Manual (Page 79)

74 www.gateway.com
Chapter 4: Installing Components
2
Follow the instructions in “Opening the server case” on page 66 .
3
Remove the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
4
Disconnect the SATA and power cables from the SATA-to-IDE converter board on the
back of the CD or DVD drive.
5
Remove the front panel cable from the SCSI hot-swap backplane by following the
instructions in
“Replacing the SCSI hot-swap backplane” on page 139 .
6
Press the blue release latch on the back of the CD/DVD drive carrier, then slide the
drive carrier assembly out the opening in the front panel.
SATA-to-IDE
converter board
8510702.book Page 74 Thursday, July 7, 2005 11:21 AM