Gateway 9715 - Manual (Page 149)

144 www.gateway.com
Chapter 4: Installing Components
7
Remove the new front panel I/O board from its package and place it in the chassis,
engaging the mounting tabs on the chassis with the slots in the new board.
8
Slide the front panel I/O board forward until it is seated on the mounting tabs, then
tighten the blue, captive thumbscrew to secure the board. See
“Torque settings” on
page 64 for correct tightening specifications.
9
Connect the front panel I/O board and control panel cables to the new front panel
I/O board.
10
Reinstall the processor air baffle by following the instructions in “Removing and
installing the processor air baffle” on page 67 .
11
Follow the instructions in “Closing the server case” on page 72 .
Important
Make sure that the pins on the front panel I/O board line up correctly
with the front panel cable connector.
Blue, captive thumbscrew
Mounting
tab
8510702.book Page 144 Thursday, July 7, 2005 11:21 AM