GarrettCom MNS-6K 4.1.4 - Manual (Page 76)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
75
Magnum6K25#
ipconfig ip=fe80::220:6ff:fe25:ed80 mask=ffff:ffff:ffff:ffff::
Action Parameter Missing. "add" assumed.
IPv6 Parameters Set.
Magnum6K25#
show ipv6
IPv6 Address : fe80::220:6ff:fe25:ed80 mask : ffff:ffff:ffff:ffff::
Magnum6K25#
show ipconfig
IP Address
: 192.168.5.5
Subnet Mask : 255.255.255. 0
Gateway Addr : 192.168.5.1 ess
IPv6 Address : fe80::220:6ff:fe25:ed80 mask : ffff:ffff:ffff:ffff::
IPv6 Gateway : ::
Magnum6K25#
F figuring IPv6
n addition to the commands listed above, the commands which support IPv6 addressing are
yntax ftp - ftp to an IPv6 station
Example – ftp fe80::220:6ff:fe25:ed80
yntax telnet - telnet to an IPv6 station
Example – telnet fe80::220:6ff:fe25:ed80
Besides, if the end station supports IPv6 addressing (as most Linux and Windows systems do),
http://fe80::220:6ff:fe25:ed80
IGURE 50 – Con
I
S
S
one can access the switch using the IPv6 addressing as shown in the example below
List of commands in this chapter
Syntax ipconfig [ip=] [mask=] [dgw=]
[add|del] – configure and IPv6 address. The add/delete option can be used to add or delete
IPv4/IPv6 addresses
– di Syntax show ipconfig splay the IP configuration information – including IPv6 address
n
tion
Syntax ping6 - pings an IPv6 station
Syntax show ipv6 - displays the IPv6 information
Syntax ftp - ftp to an IPv6 statio
Syntax telnet - telnet to an IPv6 sta