GarrettCom MNS-6K 4.1.4 - Manual (Page 225)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
• Auto – lets IGMP control whether the port should or should not participate sending
multicast traffic
• Block – manually configures the port to always block multicast traffic
• Forward – manually configures the port to always forward multicast traffic
To set the port characteristics, use the set-port in the IGMP configuration command mode
Syntax set-port port=< port|list|range> mode= - set the port
characteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicasts
Syntax show-port – display the port characteristics for IGMP
Syntax show-router – displays detected IGMP-enabled router ports
Syntax set-leave - enables or disables the switch to immediately process a host
sending a leave message rather that wait for the timer to expire
Syntax set-querier - enables or disables a switch as IGMP querier
Syntax set-qi interval= - The IGMP querier router periodically sends general host-query
messages. These messages are sent to ask for group membership information. This is sent to the all-
system multicast group address, 224.0.0.1. The default value is 125 seconds. The valid range can be
from 60 to 127 seconds.
Syntax set-qri interval= - The query response interval is the maximum amount of time that
can elapse between when the querier router sends a host-query message and when it receives a response
from a host. The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions
apply to the maximum value because of an internal calculation that is dependent on the value of the
Query Interval.
Magnum6K25#
igmp
Magnum6K25(igmp)##
set-port port=10-12 mode=forward
Port mode is set.
Magnum6K25(igmp)##
set-port port=14-16 mode=block
Port mode is set.
Magnum6K25(igmp)##
show-port
-----------------------------------
Port | Mode
-----------------------------------
09
Auto
224