Igure, 84 – stp port status information – GarrettCom MNS-6K 4.1.4 User Manual
Page 151
M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
150
Designated Root: shows the MAC address of the bridge in the network elected or
esignated as the root bridge. Normally when STP is not enabled the switch designates
rity: shows the designated root bridge’s priority. Default value is
2768
ridge Forward Delay: indicates the designated root bridge’s forward delay. This
the time the switch waits before it switches from the listening to the forwarding state.
hello time. Hello
formation is sent out every 2 seconds
signated root bridge’s maximum age – after which
discards the information as being old and receives new updates
ty”, “cost”, “port” and
timers” commands described later in this chapter.
K25#
show stp ports
d
itself as the root switch
Designated Root Prio
3
Root B
is
The default is 15 seconds. This value can be set between 4-30 seconds
Root Bridge Hello Time: indicates the designated root bridge’s
in
Root Bridge Max Age: indicates the de
it
These variables can be changed using the “priori
“
Magnum6
STP Port Configuration
--------------------------------------------------------------------------------------------------------------------------
Port# Type
Priority
Path
Cost State
Des. Bridge
Des. Port
--------------------------------------------------------------------------------------------------------------------------
09 TP(10/1
128
100
Disabl
80:00:00:20:0
80:09
00)
ed
6:25:ed:80
10 TP(10/100)
128
100
Disabled 80:00:00:20:06:25:ed:80 80:0a
11 TP(10/100) 128
100
Disabled 80:00:00:20:06:25:ed:80 80:0b
12 TP(10/100) 128
100
Disabled 80:00:00:20:06:25:ed:80 80:0c
13 TP(10/100)
128
100
Disabled 80:00:00:20:06:25:ed:80 80:0d
14
TP(10/100 128
100
Disabled 80:00:00:20:06:25:ed:80
80:0e
15 TP(10/100) 128
100
Disabled 80:00:00:20:06:25:ed:80 80:0f
16
TP(10/100) 128
100
Disabled 80:00:00:20:06:25:ed:80 80:10
Magnum6K25#
F
IGURE
84 – STP Port status information
Port#: indicates the port number. Value ranges from 01 to max number of ports in the
ndicates the type of port – TP indicates Twisted Pair
The variables shown above are
switch
Type: i