GarrettCom MNS-6K 4.1.4 - Manual (Page 296)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax lll del port= - disable LLL on the list of specified ports
Syntax show lll – display the status of LLL
Syntax rstp – STP Configuration mode
Syntax rstp - Start (Enable) or stop (Disable) STP
Syntax set stp type= - set the spanning tree protocol to be IEEE 802.1d or 802.1w (Rapid
Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Chapter 15 – Dual-Homing
Syntax dualhome – enter the dual-homing configuration sub-system
Syntax dualhome – enable or disable dual-homing
Syntax dualhome add port1= port2= – dual-homing setup similar to that of
unmanaged switches such as ESD42
OR
Syntax dualhome add primary= secondary= – dual-homing setup as primary-
secondary mode
Syntax dualhome del – Delete the dual-homing setup
Syntax show dualhome – Display dual-homing status
Chapter 16 – Link Aggregation
Control Protocol (LACP)
Syntax lacp - enable the LACP configuration module within CLI
Syntax lacp - enable or disable LACP
Syntax
add port= [priority=<0-65535>] – add the specified list of ports to
form the logical LACP trunk. Default value for priority is 32768. The lower the value assigned to
295