GarrettCom MNS-6K 4.1.4 - Manual (Page 159)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
158
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
Magnum6K25(stp)##
F
IGURE
86 – Configuring STP parameters
List of commands in this chapter
his
command lists the switch’s full STP configuration, including ge
s
rt (Enable) or stop (Disable) STP
-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports a -
Syntax c
rt(s)
have to be specified
Syntax p ber|list|range> status= - specific ports may not need to
participate in STP process. These ports typically would be end-stations. If you
Syntax timers forward-delay=<4-30> hello=<1-10> age=<6-160> - change the STP Forward
Delay, Hello timer and Aging timer values
Syntax show stp - regardless of whether STP is enabled or disabled (default) t
neral settings and port settings
tp – STP Configuration mode Syntax
Syntax stp - Sta
Syntax priority [port=] value=<0-255 | 0
nd their value is 0
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
ost port= value=<0-65535> - cost is specific to a port and the po
ort port=
are not sure – let MNS-6K
software make the decisions