GarrettCom MNS-6K 4.1.4 - Manual (Page 295)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax priority [port=] value=<0-255 | 0-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports and their value is 0-
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
Syntax cost port= value=<0-65535> - cost is specific to a port and the port(s)
have to be specified
Syntax port port= status= - specific ports may not need to
participate in STP process. These ports typically would be end-stations. If you are not sure – let MNS-6K
software make the decisions
Syntax timers forward-delay=<4-30> hello=<1-10> age=<6-160> - change the STP Forward
delay, Hello timer and Aging timer values
Chapter 14 – S-Ring and Link-Loss-
Learn
Syntax authorize key= - activate the S-Ring capabilities. Don’t forget to use
the “save” command to save the key
Syntax stp – STP Configuration mode
Syntax stp - Start (Enable) or stop (Disable) STP
Syntax set stp type= - set the spanning tree protocol to be IEEE 802.1d or 802.1w (Spanning
Tree Protocol or Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show s-ring – show the status of S-ring status and configuration
Syntax s-ring - enable or disable S-ring capabilities
Syntax s-ring learn – start the learning process to discover the ring and the ports which make up the S-ring
Syntax s-ring add port= - define ports which make up the S-ring ports. Note as discussed
earlier, you can create multiple s-rings on a switch
Syntax s-ring del port= - remove the switch from S-ring topology by eliminating the end ports
on the switch
Syntax lll - enable or disable LLL on the switch
Syntax lll add port= - enable LLL on the list of specified ports
294