GarrettCom MNS-6K 4.1.4 - Manual (Page 186)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Link-Loss-Learn Enabled.
Magnum6K25(stp)##
lll add port=1,2,3
Added Ports: 1,2,3
Magnum6K25(stp)##
show lll
Link-Loss-Learn Status:
LLL Status: ENABLED
LLL Enabled on Ports: 1,2,3
Magnum6K25(stp)##
lll del port=2,3
Deleted Ports: 2,3
Magnum6K25(stp)##
lll disable
Link-Loss-Learn Disabled.
F
IGURE
97 – Link Loss Learn (LLL) setup. Setup LLL on ports connected to other switches
participating in S-Ring
List of commands in this chapter
Syntax authorize key= - activate the S-Ring capabilities. Don’t forget
to use the “save” command to save the key
Syntax stp – STP Configuration mode
Syntax stp - Start (Enable) or stop (Disable) STP
Syntax set stp type= - set the spanning tree protocol to be IEEE 802.1d or 802.1w
(Spanning Tree Protocol or Rapid Spanning Tree Protocol)
Syntax show active-stp – Display which version of STP is currently active
Syntax show s-ring – show the status of S-Ring status and configuration
Syntax s-ring - enable or disable S-Ring capabilities
Syntax s-ring learn – start the learning process to discover the ring and the ports which make up the S-
Ring
Syntax s-ring add port= - define ports which make up the S-ring ports. Note as
discussed earlier, you can create multiple S-Rings on a switch
Syntax s-ring del port= - remove the switch from S-Ring topology by eliminating the
end ports on the switch
Syntax lll - enable or disable LLL on the switch
185