GarrettCom MNS-6K 4.1.4 - Manual (Page 163)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax rstp - enable RSTP – by default, this is disabled and has to be manually
activated
Syntax port port= [status=]
[migration=] [edge=] [p2p=]
Example port port= p2p= off - Set the “point-to-point” value to off on
all ports that are connected to shared LAN segments (i.e. connections to hubs). The default
value is auto. P2P ports would typically be end stations or computers on the network
Example port port= edge=enable – enable all ports connected to
other hubs, bridges and switches as edge ports
Example port port= migration=enable – set this for all ports
connected to other devices such as hubs, bridges and switches known to support IEEE 802.1d
STP services, but cannot support RSTP services
p2p - This parameter is used to tell the port if it is connected to another switch or a hub
or a bridge device. This parameter should be set to off for all ports that are
connected to a shared device such as a hub. GarrettCom Inc. recommends setting
this parameter to auto so that MNS-6K will automatically set the proper value for
the network
edge – this parameter is used to tell if the port is connected to an edge device such as a
computer or other such device. Disable this feature for a port connected to
another device such as a switch, bridge or a hub.
Syntax show active-stp – status whether STP or RSTP is running
Syntax show rstp – display the RSTP or STP parameters
Magnum6K25#
rstp
Magnum6K25(rstp)##
show rstp config
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
Magnum6K25(rstp)##
rstp enable
Successfully set the RSTP status
Magnum6K25(rstp)##
show active-stp
Current Active Mode: RSTP.
RSTP is Enabled.
Magnum6K25(rstp)##
show rstp config
162