beautypg.com

Chapter 19 - gvrp – GarrettCom MNS-6K 4.1.4 User Manual

Page 298

background image

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E


Syntax
group add ip= port= vlan= - add ports to a

specific IGMP broadcast

group del ip= - delete ports from a specific IGMP broadcast group

Syntax
show-group – shows the multicast groups

Syntax
set-port port=< port|list|range> mode= - set the port

characteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicasts


Syntax show-port – display the port characteristics for IGMP

Syntax show-router – displays detected IGMP-enabled router ports

Syntax set-leave - enables or disables the switch to immediately process a host sending a

leave message rather that wait for the timer to expire


Syntax
set-querier - enables or disables a switch as IGMP querier

Synta
x set-qi interval= - The IGMP querier router periodically sends general host-query messages.

These messages are sent to ask for group membership information. This is sent to the all-system multicast
group address, 224.0.0.1. The default value is 125 seconds. The valid range can be from 60 to 127
seconds.


Syntax
set-qri interval= - The query response interval is the maximum amount of time that can

elapse between when the querier router sends a host-query message and when it receives a response from a
host. The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions apply to the
maximum value because of an internal calculation that is dependent on the value of the Query Interval


Syntax
mode= - Toggle the IGMP mode from L2 to nnormal or IGMP-L2

Chapter 19 - GVRP


Syntax

show gvrp - shows whether GVRP is disabled, along with the current settings for the maximum

number of VLANs and the current Primary VLAN


Syntax

gvrp > - enable or disable GVRP


Syntax

show-vlan – list all the VLANs (including dynamic VLANs) on the switch


Syntax
set-ports port= state= - set the state of the port
to learn, block or disable for GVRP. Note the default state is disable


Syntax
static vlan= - convert a dynamic VLAN to a static VLAN

297

This manual is related to the following products: