GarrettCom MNS-6K 4.1.4 - Manual (Page 293)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax start vlan= activate the VLAN configuration
Syntax save save the configuration (including the VLAN configuration)
Syntax edit id= [name=] port=
[] - edit existing VLAN name
Syntax show vlan [] display specific VLAN information
Syntax set-port port= default id= sets the default VLAN id.
For Magnum 6K family of switches, the default VLAN id is 1, unless changed using this command
Syntax set-port port= filter status= enables or disables
the VLAN filtering function.
Syntax set-port port= tagging id= status=
untagged> defines whether the outgoing packets from a port will be tagged or untagged.
Syntax set-port port= join id= adds the specified port(s) to the
specified VLAN id
Syntax set-port port= leave id= releases a specific port from a
VLAN
Syntax show-port [port=] shows all parameters related to tag vlan for the list of ports.
If the port parameter is omitted, it will display all ports
Chapter 12 – Spanning Tree
Protocol (STP)
Syntax show stp - regardless of whether STP is enabled or disabled (default) this
command lists the switch’s full STP configuration, including general settings and port settings
Syntax stp – STP Configuration mode
Syntax stp - Start (Enable) or stop (Disable) STP
Syntax priority [port=] value=<0-255 | 0-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports and their value is 0-
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
Syntax cost port= value=<0-65535> - cost is specific to a port and the port(s)
have to be specified
292