GarrettCom MNS-6K 4.1.4 - Manual (Page 68)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
List of commands in this chapter
Syntax set bootmode type= [bootimg=]
[bootcfg=[] – assign the boot mode for the switch
Where
- where
dhcp – look only for DHCP servers on the network for the IP address. Disable
bootp or other modes
bootp – look only for bootp servers on the network. Disable dhcp or other mode
manual – do not set the IP address automatically
auto - the switch will first look for a DHCP server. If a DHCP server is not found,
it will then look for a BootP server. If that server is not found, the switch will
check to see if the switch had a pre-configured IP address. If it did, the switch
would be assigned that IP address. If the switch did not have a pre-configured
IP address, it would inspect if the IP address 192.168.1.2 with a netmask of
255.255.255.0 is free. If the IP address is free, MNS-6K will assign the switch
that IP address. If the address is not free, MNS-6K will poll the network for
DHCP server then BootP server then check if the IP address 192.68.1.2 is freed
up
bootimg= - valiad with type=bootp only. Allows the switch to load
the image file from the BootP server. This is useful when a new switch is put on a
network and the IT policies are set to load only a specific MNS-6Kimage which is
supported and tested by IT personnel.
bootcfg= - valiad with type=bootp only. Allows the switch to load
the configuration file from the BootP server. This is useful when a new switch is put
on a network and the specific configurations are loaded from a centralized BootP
server
Syntax telnet - enables or disables telnet sessions
Syntax telnet [port=] – telnet from the switch
Syntax ssh - enable or disable the server. Also can be used for generating the
key used by ssh
Syntax ssh port= - select a different port number for SSH communication
Syntax show ssh – display the ssh settings
Syntax set dns [server=] [domain=] - specify
a DNS server to look up domain names. The sever IP can be a IPV6 address as well as an IPV4
address
Syntax show dns – display the DNS settings
67