GarrettCom MNS-6K 4.1.4 - Manual (Page 284)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
bootcfg= - valid with type=bootp only. This option allows the switch
to load the configuration file from the BootP server. This is useful when a new switch
is put on a network and the specific configurations are loaded from a centralized
BootP server
Syntax telnet - enables or disables telnet sessions
Syntax telnet [port=] – telnet from the switch
Syntax ssh - enable or disable the server. Also can be used for generating the
key used by ssh
Syntax ssh port= - select a different port number for SSH communication
Syntax show ssh – display the ssh settings
Syntax set dns [server=] [domain=] - specify
a DNS server to look up domain names. The sever IP can be a IPV6 address as well as an IPV4
address
Syntax show dns – display the DNS settings
Syntax set serial [baud=] [data=<5|6|7|8>] [parity=]
[stop=<1|1.5|2>] [flowctrl=] – sets serial port parameters
Syntax snmp – enter the snmp configuration mode
Syntax setvar [sysname|syscontact|syslocation]= - sets the system name, contact and
location information
Syntax set timezone GMT=[+ or -] hour=<0-14> min=<0-59> - sets the timezone
Syntax set date year=<2001-2035> month=<1-12> day=<1-31>
[format=] – sets the date and the format in which the
date is displayed
Syntax
set time hour=<0-23> min=<0-59> sec=<0-59> – sets the time (as well as the timezone)
Syntax
set timeformat format=<12|24> - sets the display time in the 12/24 hour mode
Syntax set daylight country=< country name> - sets the daylight saving time
Syntax setsntp server = timeout = <1-10> retry = <1-3> - setup the SNTP server
Syntax sync [hour=<0-24>] [min=<0-59>] – setup the frequency at which the SNTP server is queried
Syntax sntp [enable|disable] – enables or disables the SNTP services
283