GarrettCom MNS-6K 4.1.4 - Manual (Page 353)

U P D A T I N G S O F T W A R E – S T E P 4
Step 4
4. (Optional Step) Restoring the
configuration
Optionally, restore back the original configuration and update the boot code…..
t this optional step, the original configuration has been saved, MNS-6K image copied from the
www.garrettcom.com site and then onto the Magnum 6K switch and finally, if required, the
configuration can be restored using the instructions in this step. If the Magnum 6K switch is
updated over the network, it maybe necessary to update the boot code.
A
Accessing the switch
Continue to use the access method defined in steps 1, 2 and 3.
Reloading the configuration
The command used for restoring the original configuration is
Syntax loadconf mode= [] [file=]
Where
mode is the mode by which the configuration file will be accessed for upload – serial, ftp or tftp
ipaddress is the IP address of the ftp or tftp server (only used when mode = ftp or tftp)
file=name is the name of the configuration file
At this stage, follow the same process for uploading the files as described in step 3. The file that needs to
be uploaded is the configuration file which was saved in step 2 (as shown in
Figure 7 or Figure 12 .)
352