Waves eMotion LV1 64-Channel Mixer with Axis One Custom Computer - Manual (Page 119)

114
Waves eMotion LV1 User Guide | Chapte r 3 : Channel Window
Window
I
NPUT SECTION
The Input section of the Talkback channel patches to any hardware or software I/O that’s assigned to the mixer. It can control preamp
analog level, 48v, and phase in the same manner as Input channels. The section includes input meters and peak value indicators, as well as
input trim controls, assigned filter adjustment, and delay control.
P
LUGINS RACK
The Talkback channel accepts up to eight plugins. There is no Main Control section on this Channel page, so plugins are controlled directly
on the plugin pane. Refer to the Channel > Rack section to learn more about using the plugins rack.
T
ALKBACK SOURCE
The Talkback buss can be routed to any available I/O. It can also be routed to mixer busses, including Main outs. This grid is used to
determine which busses the Talkback channel is patched to. If All is selected, Talkback is patched to every buss.
T
ALKBACK ROUTING PRESETS
Up to eight Talkback routing configurations can be saved as presets.
a. Select a preset button.
b. Configure Talkback buss assignments.
c. Click Save.
The Clear button removes all patches visible on the grid. It does not affect saved presets.
O
UTPUT SECTION
The Output section of the Talkback page is identical to that of the Cue channel. Select Open List and add output assignments. A fader
Section includes fader, pan/balance/rotate control, and mute, as well as direct output assignments. For details, please refer to the
Channel Output section (earlier in this chapter).
T
ALK B UTTON
(
ON THE
T
OP
B
AR
)
Talkback is activated with the non-latching Talk switch. It must be held open to talk. When Talkback is On, the top part
of the button is blue. Click the Gear icon below TALK to directly access the Cue channel page from any window.
Talkback On/Off can also be mapped to a control surface or assigned to user-assignable keys, which are set up in the U/I
Settings window (Setup > U/I Settings > User-Assignable Keys).
U
SING
T
ALKBACK T O D ISTRIBUT E A TEST SIGNAL
Since Talkback can be sent to any I/O or buss, it is a convenient way to broadcast a reference tone or other test signal. Insert a signal
generator in the Talkback plugins rack. This signal will be distributed to all selected busses and I/Os.