Biamp LTR - Manual (Page 39)

Introduction
The Digital Audio Platform shall be AUDIA®.
AudiaSOLO Digital Audio Platform
ARCHITECT'S & ENGINEER'S SPECIFICATION
The Digital Audio Platform shall be available in three hardware
configurations: 8-in/8-out (8x8); 12-in/4-out (12x4); and 4-in/12-out
(4x12). Inputs and outputs shall be analog, with internal 24-bit A/D &
D/A converters operating at a sample rate of 48kHz. All internal
processing shall be digital (DSP). Electronically balanced inputs and
outputs shall be provided on plug-in barrier-strip connectors. Inputs
shall be individually programmable to accept either microphone or line
level signals. The 12x4 configuration shall allow inputs 11 & 12 to be
set for mono summing of unbalanced stereo line level signals. Outputs
shall normally provide line level signals, however, the 4x12
configuration shall allow outputs 1~4 to be individually programmed to
provide microphone level signals.
Each hardware configuration shall include six 60MHz 32-bit floating
point DSPs, an 80MHz 32-bit host processor, 32MB SDRAM, and 8MB Flash
ROM. Software shall be provided for creating/connecting DSP system
components within each hardware unit. Available system components shall
include (but not be limited to) various forms of: mixers, equalizers,
filters, crossovers, dynamics/gain controls, routers, delays, remote
controls, meters, generators, and diagnostics. Ethernet communications
shall be utilized for software control and configuration. After initial
programming, systems may be controlled using either TCP/IP or RS-232
serial communication by third party control systems (such as AMX® and
Crestron®), by PC computer, and/or by dedicated remote control devices.
Software shall operate on a PC computer, with network card installed,
running Windows® XP Professional/Vista.
The Digital Audio Platform
shall be CE marked, UL/C-UL listed, and carry a five-year warranty.
The Digital Audio Platform shall be AudiaSOLO.
AudiaFLEX Digital Audio Platform
ARCHITECT'S & ENGINEER'S SPECIFICATION
The Digital Audio Platform shall be available in various I/O
configurations. Inputs/outputs shall be specified in pairs, up to a
total of 24. Mic/line Input (IP-2), Acoustic Echo Cancellation (AEC-
2HD), Telephone Interface (TI-2), Mic/Line Ouput (OP-2e), and Amplifier
Ouput (PA-2) input/output options shall be available. Inputs/outputs
shall be analog, with internal 24-bit A/D & D/A converters operating at
a sample rate of 48kHz. All internal processing shall be digital (DSP).
Electronically balanced inputs and outputs shall be provided on plug-in
barrier-strip connectors. Inputs and outputs shall be individually
programmable for either microphone or line level signal. Expansion
units, utilizing CobraNet®, shall be available in 8-channel versions,
for adding analog or digital inputs/outputs to a system.
19