Cobranet® input, Cobranet, Input – Biamp LTR User Manual
Page 101
Component Objects
When using AudiaFLEX
, an Enable
Output Attenuation
check-box may be selected
when placing an Output block into the Layout from
the
. With newer OP-2e output cards,
this allows the Full Scale Out reference level to be
changed on individual outputs, from +24dBu to
OdBu in 6dB steps, or -31dBu (mic level). NOTE:
Earlier OP2 output cards support only line or mic
level output. Therefore, settings other than -31dBu
(mic level) will result in a +24dBu (line level) output.
If standard Audia or AudiaSOLO
is being
used, then mic level output is selectable only on
4x12 configurations (see
).
When using regular Output blocks with standard
Audia or AudiaSOLO hardware, Enable Output
Attenuation must remain un-checked, for the
to consider such hardware.
CobraNet
®
Input
Adjust external signal source so Peak In flashes only
occasionally (6dB headroom). Mute In turns the input signal
on/off. Level In adjusts the relative input volume. Invert In
reverses the polarity of the input signal.
CobraNet Bundle
assigns digital audio data to a particular
bundle number. CobraNet Bundle Numbers are used to match
those of any external third-party CobraNet A/D converters being
used in the system (see
). Normally, 'unicast' bundles
256 ~ 65,279 are selectable. These are device specific bundles
(for exchange of digital audio with only one other device).
Multicast
allows selection of bundles 1 ~ 255, which are not
device specific (for exchange of digital audio with multiple
devices). Enable turns on/off the exchange of CobraNet digital
audio data from this device.
Note: CobraNet Input blocks now include an
field to assist in
signals going through third-party CobraNet output devices. The
propagation delay through the Audia system, the CobraNet
transmission delay (according to the currently selected
) and the internal propagation delay in the third-party
equipment will be correctly taken into account.
The "Default"
setting for this field only takes into account the propagation delay
through the Audia system (0.67mS).
Right-clicking over certain settings will provide a menu of
additional options.
81