Biamp LTR - Manual (Page 144)

Audia-Manual-LTR
Right-clicking over the object provides a pop-up menu of options.
Control Dialogs
Router
Routers allow each input to be assigned to multiple outputs via In / Out.
However, each output allows only one input assigned at a time.
Therefore, Routers behave like a series of individual distribution
amplifiers. For increased input/output assignment capability, see
Mixers .
Right-clicking over certain settings will provide a menu of additional
options.
Paging Zone Router
The Paging Zone Router is intended exclusively for use with Networked Paging Station-1 inputs.
When placed from the Object Toolbar, a
Paging Zone Router may have up to 32
inputs (Station Count) and 28 outputs (Zone
Count), as well as logic control output
nodes indicating zone (output) activity.
Inputs are for connection of Networked
Paging Station-1 signals. Outputs are for
connection to speaker zones. Additional
processing blocks may be employed at the
inputs/ouputs of the Paging Zone Router,
however, only 'non-mixing/non-delay' blocks
(such as Equalizers and Levelers) may be
placed between Networked Paging Station-
1 and Paging Zone Router blocks. Paging
Zone Routers may not be included in
system presets.
A Paging Zone Router normally reserves 16 channels
of
CobraNet for routing of audio and control signals. If
necessary, fewer channels may be specified in the
Object Property Sheet . However, the number of
reserved CobraNet channels will determine the
maximum number of simultaneous pages allowed.
124