Biamp LTR - Manual (Page 162)

Audia-Manual-LTR
Control Labels
The Volume 8, Select 8, and Volume/Select 8 controls all come with a sheet of clear,
adhesive-backed labels, for custom printing on a laser printer. A Word document is available
on the Audia® software CD and on the Biamp web site (www.biamp.com), as a label printing
template. These labels are meant to be printed using desk-top laser printers only. It is
recommended that the printer be set for 'label' printing, and the label sheet should be 'short-
edge' feed from the 'bypass' tray. A test printing of a single label should be done, to assure
proper alignment of text. To compensate for any mis-alignment of text, margins within the
Word document may be adjusted. Care should be taken in placement of the labels onto the
controls. To avoid finger-prints, the use of a knife-blade or tweezers is recommended for
handling. Severe bending or curling of the label may cause loss of some toner (text). When
placing the label on the control panel, use the vertical column of LED indicators as a visual
reference of alignment. Once the label is in place, a second (un-printed) label may be placed
over the first label, to provide protection against wear. Each sheet contains 25 labels, so in
case of errors, additional labels may be printed.
NOTE: Originally, labels were 1.35" wide and used the Word document (V8S8 Labels.doc).
However, newer control panels require labels which are only 1.25" wide and use Word
document (V8S8 B Labels.doc). Check label width and use the appropriate file for printing.
142