Biamp LTR - Manual (Page 177)

System Design
Explanation: A source, other than an Auto Mixer Main Output, is connected to a
Mix-Minus Combiner input. Mix-Minus Combiners allow Auto Mixers to share
control data only, and do not support audio input or output.
Message: The main output of an Auto Mixer is connected to more than one
Combiner block.
Explanation: The main output of an Auto Mixer can be connected to only a single
Combiner input ( Mix-Minus or Room ). Otherwise, Auto Mixer control
data might be shared with multiple groups of combined mixers, causing
convoluted behavior.
Messages: Incomplete signal path for Telephone Interface Receive block
(object code '__') at [__,__].
Incomplete signal path for Telephone Interface Transmit block
(object code '__') at [__,__].
Explanation: Each functional Telephone Interface (TI-2 card channel) must have both
the Receive and the Transmit blocks properly connected.
Message: Empty layout !
Explanation: No objects have been placed in the layout .
Messages: There are no audio sources or destinations.
There are no audio sources.
There are no audio destinations.
Explanation: No audio input/output objects have been placed (or connected) in the
layout .
Messages: Some DSP blocks do not have inputs. Ignore them ?
Some DSP blocks do not have outputs. Ignore them ?
Explanation: These messages appear only if the flag 'Prompt To Stop Compilation
On Warnings' is set under Tools>Options>Compile . If the choice to
157