Biamp LTR - Manual (Page 213)

System Control
Speed Dial
Entry to Dial
TISPEEDDIAL DIAL None 1 ~ 16
Phone Number
to Dial
TIPHONENUM DIAL None enter the phone
number
Redial TILASTDIALED DIAL None none
Note : The TI-2 can insert delay while dialing a phone number by inserting commas where desired
(each comma provides 1 second of delay). Most PBX systems require delay after acquiring an
outside line. Also, multiple TIPHONENUM commands can be used to dial the individual digits of a
phone number. The TIPHONENUM command has a character limit of 32 characters for the
"value" field.
Example: Get Device 1 TI-2 Caller ID Information at Instance 23
Command Dev # Attribute Inst ID Index 1 Index 2 Value Line Feed
GET 1 TICID 23 None None None
Result: GET 1 TICIDUSER 23
Note: GET 1 TICID 23 will return: "" if there is no caller ID information available. If there is CID
information available, it will return in the format "MMDDHHmmXXXXXXXXXX" where the "X's"
represent the ten digit phone number. For example "040211235035551212".
Example: Get Device 1 TI-2 Full User Caller ID Information at Instance 23
Command Dev # Attribute Inst ID Index 1 Index 2 Value Line Feed
GET 1 TICIDUSER 23 None None None
Result: GET 1 TICIDUSER 23
Note: GET 1 TICIDUSER 23 will return: "" "" "" if there is no caller ID information available. The
first set of quotes contains the date and time in the format MMDDHHmm. The second set of
quotes represents the incoming phone number in the format 5036417287. The third set of quotes
contains the name of the caller. If there are quotes contained within the name, there will be a
backslash preceding the quotes within the name, i.e. "David \"Dawg\" Grisman".
193