Biamp LTR - Manual (Page 33)

Introduction
DIAL commands received after the call is connected are sent immediately (as DTMF tones). The
dialer can insert delay while sending DTMF tones by inserting commas where desired (each
comma provides ½ second of delay).
Redial and Speed Dial numbers are assumed to be complete dial strings and do not require # (or
wait for a dialing timeout) to be sent. Redial includes only the dial string used to connect the
previous call and does not include DTMF tones sent during the connection.
Both ANS 1 VOIPCALL 104 1 and SET 1 VOIPHOOKSTATE 104 1 0 will answer an incoming
call. Both END 1 VOIPCALL 104 1 and SET 1 VOIPHOOKSTATE 104 1 1 will end a call in
progress.
VoIP Receive Attribute Commands Index Value Range
Receive Level VOIPRXLVL SET, SETL, GET, GETL,
INC, DEC 1 -100 ~ 12 *
CPT Level VOIPRXCPTLVL SET, SETL, GET, GETL,
INC, DEC 1 -100 ~ 0 *
Mute VOIPRXMUTE SET, GET 1 0 = unmuted
1 = muted
* Can contain a decimal number.
VoIP Transmit Attribute Commands Index Value Range
Transmit Level VOIPTXLVL SET, SETL, GET, GETL,
INC, DEC 1 -100 ~ 0 *
Mute VOIPTXMUTE SET, GET 1 0 = unmuted
1 = muted
* Can contain a decimal number.
Device Attribute Commands Index Value Range
VoIP FW Ver VOIPFWVER GET None Major.Minor (ex: 1.90)
Device FQ Ver DEVFWVER GET None (ex: 3.307-2.3-4.510)
13