Biamp LTR - Manual (Page 121)

Component Objects
STATUS
This display window provides an overview of many relevant network settings. When
disconnected, a message appears in the Network Status window stating: "Unavailable when not
connected."
The "Codec Last Used" field will state unknown when a VoIP-2 card is first installed. The field
will update with the actual last used codec after a call has been completed.
Note: Configuration of the proxy server may require the MAC address of the VoIP Interface, and
this information is displayed as the first line in network status. The proxy server and outbound
proxy server lines will display the address of the server that the VoIP line is registered with. If the
line has not yet registered, these entries will be blank.
Power Amp
Power Amps provide amplified outputs to directly
drive 4, 6, or 8 ohm speaker systems, and are
available in channel pairs only as part of AudiaFLEX
hardware . When placed into the Layout from the
Object Toolbar, Power Amps are software
configurable for 5 ~ 30 Watts per channel (10 ~ 60
Watts mono-bridged). An upgraded AudiaFLEX
power supply provides an additional 120 Watts of
power, supporting up to 24 Power Amp channels (12
PA-2 cards) @ 5 Watts per channel. The combined
wattage of all Power Amps in an AudiaFLEX chassis
101