Biamp LTR - Manual (Page 113)

Component Objects
Double-clicking the Control/Status block produces a
control dialog box.
Device IO indicates which
hardware input is associated with that software
channel. Auto Disconnect provides three methods
of call termination (the method used depends on
the far-end equipment). Loop Drop detects
interruptions in the current of the telephone circuit,
Call Progress detects a special tone indicating call
termination, and some far-end equipment may use
a combination of Loop Drop + Call Progress.
NOTE: Auto Disconnect reliability may be affected
by intermittent line interruptions or cellular calls.
Line displays voltage, current, and fault conditions
on the line.
NOTES: Before compiling, a Country must be designated in the Receive block Property Sheet .
For protection of privacy, the Last Number Dialed and Caller ID displays (on the Dialer control
dialog box) can be disabled via the Control/Status block
Property Sheet . Sidetone Level can be
set via the Dialer block Property Sheet .
VoIP Interface
VoIP (Voice over Internet Protocol) Interface blocks provide connection and control via standard
Ethernet lines to SIP-based IP telephone systems, and are available only as part of AudiaFLEX
hardware . A VoIP Interface consists of three separate blocks as placed through the Object
Toolbar ; two blocks represent the audio Receive and Transmit functions and a Console block is
used to set up and configure the VoIP Interface. A single VoIP Interface can support up to two
independent, simultaneous IP calls, each with its own audio path.
The country is user set when the block is initialized in software. This setting controls what Call
Progress Tones are generated and understood. This setting is made per card and governs both
lines.
The Receive block provides an output mix of incoming audio and
internal ring tone signals for two IP phone lines. Double-clicking the
Receive block produces a control dialog box.
93