HP 7200 - Manual (Page 43)

Paper Tips
HP papers ● HP Premium Paper: Locate the gray arrow on the nonprinting side
of the paper, and then slide the paper into the input tray with the
arrow side facing up.
● HP Premium Inkjet Transparency Film: Insert the film so that the
white transparency strip (with arrows and the HP logo) is on top
and is going into the input tray first.
Note The HP All-in-One might not automatically detect
transparency film if it is loaded incorrectly, or if you use
transparency film other than HP transparency film. For best
results, set the paper type to transparency film before printing or
copying onto transparency film.
● HP Iron-On Transfers: Flatten the transfer sheet completely before
using it; do not load curled sheets. (To prevent curling, keep
transfer sheets sealed in the original package until you are ready
to use them.) Locate the blue stripe on the nonprinting side of the
transfer paper and then manually feed one sheet at a time into the
input tray with the blue stripe facing up.
● HP Greeting Cards, HP Photo Greeting Cards, or HP Textured
Greeting Cards: Insert a small stack of HP greeting card paper into
the input tray with the print side down; slide the stack of cards
forward until it stops.
Labels
(for printing from a
software application
only) Always use letter or A4 label sheets designed for use with HP inkjet
devices (such as Avery inkjet labels), and make sure that the labels are
no more than two years old. Labels on older sheets might peel off
when the paper is pulled through the HP All-in-One, causing paper jams.
1.
Fan the stack of labels to make sure none of the pages are
sticking together.
2. Place a stack of label sheets on top of full-size plain paper in the
input tray, label side down. Do not insert labels one sheet at a time.
Continuous banner
paper
(for printing from a
software application
only) Continuous banner paper is also known as computer or z-fold paper.
1.
Remove the output tray.
2. Remove all paper from the input tray.
Note Leave the output tray off of the HP All-in-One while the
banner prints to prevent the continuous banner paper from tearing.
3. Verify that the stack of banner paper contains at least five pages in
the stack.
Note If you use non-HP banner paper, make sure you use 20-lb.
paper.
4. Carefully tear off the perforated edge strips from both sides of the
paper stack, if any, and unfold and refold the paper to make sure
the pages do not stick together.
Chapter 5
40 HP Officejet 7200 All-in-One series
Load
originals
and
load
paper