HP 7200 - Manual (Page 147)

Parameter Description
Admin
Password Status of the administrator's password for the Embedded Web
Server:
●
Set: password is specified. You must enter the password to
make changes to the Embedded Web Server parameters.
● Not Set: no password is set. A password is not required for
making changes to the Embedded Web Server parameters.
Link
Configuration The speed at which data is transmitted over a network:
●
10TX-Full: for wired network.
● 10TX-Half: for wired network.
● 100TX-Full: for wired network.
● 100TX-Half: for wired network.
● None: networking is disabled.
Wireless network settings
The following table describes the wireless network settings shown on the network
configuration page.
Parameter Description
Wireless
Status Status of the wireless network:
●
Connected: the HP All-in-One is connected to a wireless LAN
and everything is working.
● Disconnected: the HP All-in-One is not connected to the
wireless LAN due to incorrect settings (such as the wrong
WEP key), or the HP All-in-One is out of range.
● Disabled: either the radio is turned off, or the Ethernet cable
is plugged in.
● Not applicable: this parameter does not apply to this network
type.
Communicatio
n Mode An IEEE 802.11 networking framework in which devices or
stations communicate with each other:
●
Infrastructure: the HP All-in-One communicates with other
network devices through a wireless access point, such as a
wireless router or base station.
● ad hoc: the HP All-in-One communicates directly with each
device on the network. No wireless access point is used. This
is also called a peer-to-peer network. On Macintosh networks,
ad hoc mode is called computer-to-computer mode.
● Not applicable: this parameter does not apply to this network
type.
Network
Name (SSID) Service Set Identifier. A unique identifier (up to 32 characters) that
differentiates one wireless local area network (WLAN) from
Chapter 13
(continued)
144 HP Officejet 7200 All-in-One series
Set
up
your netw
ork