Epson 3865X Plus - Manual (Page 41)

Moving the Cursor Block
Use and to move the cursor block (the highlighted bar)
through the options on the main Setup menu. After you
highlight the option you want, press Enter to select it.
you need to enter numbers while
and you want to use the numereric
turn it back on.
Follow the instructions in the rest of this chapter to use the
Setup program to define your computer’s configuration.
Setting the Display Adapter Type
The Setup program can usually detect the exact type of display
adapter you are using with your computer. If you have
connected a VGA monitor to the built-in VGA port, the Setup
program automatically sets this value for the display adapter
type. (With this option you select the type of display adapter
you are using-not the type of monitor). If you have installed a
display adapter card-or you just want
to check the display
adapter setting-follow these steps.
N o t e .
If you have installed a display adapter card that is not a VGA
or an EGA card, you must set jumper J6 an the main system
board to disable the built-in VGA interface so that your card
can operate as the primary display adapter. See Chapter 4 for
instructions on changing jumper settings.
2-6 Running the Setup Program