Epson 3865X Plus - Manual (Page 218)

6. Remove the four screws that secure the hard disk drive
mounting plate to the hard disk drive. Then remove and
store the mounting plate along with the screws.
7. Wrap the hard disk drive in its original packing materials
and set it aside. Then carefully arrange the power supply
cable and the ribbon cable so that they fit down into the
vertical mounting area inside the computer. Make sure that
the cables do not interfere with any other cables or
mechanisms.
8. Follow the steps under “Replacing the Cover,” in Chapter
5, to replace the cover on the computer. Then see “Post-
installation Setup,” later in Chapter 5, for instructions on
configuring your computer for use without your hard disk
drive.
Note
After you change your computer’s drive configuration, your
computer may make up to five minutes to complete power-on
diagnostics the next time you turn it on.
Installing or Removing a Disk Drive in the
Horizontal Position
This section describes how to install or remove a hard disk drive
or a diskette drive in the lower horizontal drive bay. You can
use these same instructions if you need to install a different
diskette drive in the upper drive bay; however, the illustrations
show the lower bay.
If you are installing a second hard disk or diskette drive, you
must install
it in the lower horizontal drive bay. Your first
diskette drive is in the upper bay and your first hard disk is in
the vertical mounting position beside the drive bays.
Installing and Removing Disk Dives B-27