Epson 3865X Plus User Manual
Page 207
Make sure the holes fit over all the pins and then push the
connector onto the pins.
4.
Pick up the hard disk drive and hold it above the vertical
mounting area so the mounting plate is facing the
subassembly, as shown below.
Notice that there are two tabs facing downward on the
bottom of the mounting plate. These tabs fit into two slots
in the right side of the subassembly when you install the
drive.
B-l6
Installing and Removing Disk Drives
See also other documents in the category Epson Computers:
- ACTIONPC 5000 (12 pages)
- EQUITY 386SX/16 PLUS (261 pages)
- Endeavor (197 pages)
- 20040 (251 pages)
- EQUITY 386SX/20 PLUS (6 pages)
- S1C33210 (559 pages)
- 2000 (231 pages)
- 2000 (129 pages)
- 486SX (233 pages)
- EISA Desktop (184 pages)
- 386 (218 pages)
- Equity 286 PLUS (263 pages)
- 10020 (238 pages)
- Equity II (79 pages)
- Equity II (151 pages)
- EQUITY Y14499113001 (139 pages)
- Equity 320SX PLUS (230 pages)
- EL 3S/33 (117 pages)
- EQUITY 3865X/20 PLUS (269 pages)
- Endeavor 468C (187 pages)
- Equity Ie Q50188015-1 (147 pages)
- LT-286 (188 pages)
- 386/25 (326 pages)
- 386SX (284 pages)
- Endeavor power (SPEED) hard disk diskette WG (8 pages)
- 486 UC+ (9 pages)
- Endeavor WG (201 pages)
- S1C63000 (152 pages)
- I+ (139 pages)
- LT - 286e (60 pages)
- LT - 286e (161 pages)
- 486SX EN (6 pages)